- Status Closed
- Percent Complete
- Task Type Bug Report
- Category
- Assigned To No-one
- Operating System
- Severity Low
- Priority
- Reported Version
- Due in Version Undecided
-
Due Date
Undecided
- Votes
- Private
Opened by nobody special - 05.07.2008
Last edited by Steven Schwartfeger - 05.07.2008
FS#1868 - Windowless tower ladder offset
Having seen some of the complaints on the forum I decided to take a look at the windowless tower. I climbed up from the temple ruins and had no trouble with the climb until I got to the very top. I got out of the temple all right but when I look back in the hole the ladder was not there, it was offset about a width and a half to the side which would have been outside the walls. I took a few pictures from the ladder: http://web.ncf.ca/cr502/ps/4.01/ ladder.png, ladder1.png ladder1a.png and ladder2.png. Unfortunately when I exited the ladder with the third person camera angle I used to take those pictures the platform surface was transparent and my client crashed. I was going to take a picture from the top to illustrate the offset but when I logged back in and went down the hole I wound up on the wrong side of the ladder. the top platform glitch was still there when I logged in.when I was back inside the tower things looked normal again but I fell to my death trying to get to the right side of the ladder. Anyway the pictures provided will probably not help much but you should be able to see the offset by looking down from on the platform.
As always I use linux.
| ID | Project | Summary | Priority | Severity | Assigned To | Progress | |
|---|---|---|---|---|---|---|---|
| 1796 | PlaneShift | Critical | Mike Gist |
05.07.2008 03:30
Reason for closing:
Additional comments about closing:
Don't blame you for not knowing this,
but it's the same issue as FS#1796
, each time you load the portals can be
different, either going to a totally
invalid place and causing a pos reset or
a crash, or offset a large amount and
placing you off the world in the
destination sector, or just slightly
offset but still usable… try
restarting ps a few times, it should
change ;)